Bottle blowing machine, automatic bottle blowing machine, plastic bottle blowing machine, PET bottle blowing machine
2 Cavity Automatic Bottle Blowing Machine--- the automatic bottle blowing machine is suitable for producing PET plastic containers and bottles in all shapes. It is widely used to produce the carbonated bottle, mineral water, pesticide bottle oil bottle cosmetics, wide-mouth bottle and hot fill bottle etc.
Features of main body:
1). Stable performance with advanced PLC.
2). Automatic preform conveyer to save human cost.
3). Preform autorotation and infrared pre-heater revolution assure the even distribution of heat, which improve the bottle shaping rate, increase the production.
4). High adjusting performance to enable preheat the preforms perfectly by adjust the voltage control area in the PLC, which could adjust the temperature of the infrared lights in the pre-heater, and keep the proper temperature and humidity invariable.
5). High safeties with security automatic-locking device in each mechanical action, which will make the production into a perfect safe environment, in case of the breakdown in certain procedure.
6). Introduce the FESTO air cylinder to avoid contamination and noise.
7). Satisfaction with different atmospheric pressure for blowing and mechanical action by dividing the blowing and action into three parts in the air pressure diagram of the machine.
8). Strong clamping force with high pressure and double crank links to lock the mould.
9). Two ways of operating: automatic and manual.
10). Safe\reliable and unique design of the position of valve to make the pneumatic diagram in the machine easier to understand.
11). Low cost\high efficiency\easy operation and maintenance etc, profited from the fully automatic technological process.
12). Ideal cooling system make the finished bottles without any flaws.
13). Easy for you to install\test and start up.
14). Low rejection rate: less than 0.2 percent.

Technical parameter:

Model                                               SHY-2
Productivity	Depend on bottle design	1800-2000pcs/h
Product type	Body diameter	≤100mm
	Height	≤310mm
	Neck diameter	18-38mm
Mold	Cavity	2cavity
	Mold thick	240mm
	Mold	260*240*370mm
Main machine power	Electrical source power	380V/220V 50/60Hz
	Rated Power	25KW
	Really use power	6-10KW
Air source	LP air compressor	1.0 m3/min 10kg
	HP air compressor	1.4 m3/min 30kg
	Air dryer	1.0 m3/min 30kg
Cooling water	Cooling water	10L/min
Size	L*W*H	1910*1858*1935mm
	Weight	2000Kg
Auxiliary equipment ( pre-form unscrambler )	L*W*H	2000*950*2480mm
	Weight	250Kg
Resin available		PET